After Adding a Power Switch Onto a LED String of Lights, Some still Light Up Very Slightly When Swit

While this doesn't answer why this is happening, you could wire your switch like this to stop the LEDs illuminating when switched off.simulate this circuit Schematic created using CircuitLab

I bought a string of lights made of white LEDs (SRDAL by that famous Swedish company) that doesn't have an on-off switch. The AC/DC converter directly plugs into the mains (220V) and I wanted to add a switch to turn it off without having to unplug it.

I bought a very simple switch from the hardware store and installed it on the leads that make up the string of lights, after the adapter since this was my only option. There are two leads on the string, and they run on 24VDC.

The switch is made so that one of the leads is interrupted mechanically when in "off" state, but the other lead is directly connected from one end to the other end of the switch by a strip of copper.

I thought this should be enough to interrupt the circuit and turn the LEDs off, which is mostly does, except some of the LEDs still light up very faintly in the "off" state.

When in the off state, I measure a very slight negative DC voltage between the two leads with my multimeter (as opposed to positive 24V when on).

Why is that? I thought it might be due to the two leads being twisted in a double helix way along the length of the string of lights, acting as inductors? Or maybe the electrical insulation between the two leads is not thick enough?

I tried connecting the negative lead to the terminals within the switch that are directly connected together (and the V wire on the interrupted side), as well as connecting the V lead to those and interrupting the negative wire, but both options still produce a faint light.

Thanks.

EDIT: this might not be important, but the LEDs are connected in parallel (I think), since there are 3 leads between any two LEDs, even though only two leads come out of the adapter.

·OTHER ANSWER:

I bought a string of lights made of white LEDs (SRDAL by that famous Swedish company) that doesn't have an on-off switch. The AC/DC converter directly plugs into the mains (220V) and I wanted to add a switch to turn it off without having to unplug it.

I bought a very simple switch from the hardware store and installed it on the leads that make up the string of lights, after the adapter since this was my only option. There are two leads on the string, and they run on 24VDC.

The switch is made so that one of the leads is interrupted mechanically when in "off" state, but the other lead is directly connected from one end to the other end of the switch by a strip of copper.

I thought this should be enough to interrupt the circuit and turn the LEDs off, which is mostly does, except some of the LEDs still light up very faintly in the "off" state.

When in the off state, I measure a very slight negative DC voltage between the two leads with my multimeter (as opposed to positive 24V when on).

Why is that? I thought it might be due to the two leads being twisted in a double helix way along the length of the string of lights, acting as inductors? Or maybe the electrical insulation between the two leads is not thick enough?

I tried connecting the negative lead to the terminals within the switch that are directly connected together (and the V wire on the interrupted side), as well as connecting the V lead to those and interrupting the negative wire, but both options still produce a faint light.

Thanks.

EDIT: this might not be important, but the LEDs are connected in parallel (I think), since there are 3 leads between any two LEDs, even though only two leads come out of the adapter.

get in touch with us
推薦的文章
What Are Some Ways to Keep My Hair Really Healthy?
Use professional shampoo & conditioner. I know it may seem like a rip-off, however all the shampoos like Pantene, Garnier, etc. have a high alcohol content....since the normal pH of your hair is 4.5-5.5, things containing high amounts of alcohol throw your hair all out of whack and cause breakage, split-ends, fly-aways, etc. The reason these shampoos make your hair feel soft is because they contain high amounts of humectants, which are just a cover for how damaging they really are! Another tip is ALWAYS use a thermal protector while applying heat. Heat appliances cause tons of damage to your hair. Usually this is a cream/clear gel you apply before blow drying. Never use a flat iron on hair that is not completely dry!1. Split End Help. ( 10 Points) !!!!!!!!!!!!!!!!!!!!!!?For sure you should get a trim and maybe even cut your hair as short as you are comfortable doing it. You should for no reason straighten or dye your hair. Look for some Garnier Fructis or Pantene shampoos and conditioner for curly hair so that it extra moisturizes it and helps the split ends repair themselves. I say from experience that ppl with curly hair have really bad split ends, which is why we have special stuff in our hair products. The split ends wont magically go away in like a month or a few weeks, but you will see improvement after a while. Oh, and for sure DO NOT PICK THEM OFF!! It will just make it worse. Every two months until your hair is healthy get a trim. just maybe half an inch or an inch will be just fine. Eventually your hair will go back to normal. Good luck with that!.2. Whats the best shampoo conditioner for cheap?clever or V05 are solid inexpensive ($a million) shampoos, yet whilst it is composed of conditioner i could bypass Tresemme ($6) it does an somewhat solid interest. i take advantage of salon shampoo because of the fact i am form of a hair snob, yet I nonetheless use the cheap conditioner. Pantene is undesirable on your hair (too plenty protein and reasons alot of greater build up on the hair) so i does not bypass there. desire this permits! My hair is oily, superb, and colour-taken care of if that helps you any!3. How can I get my curly hair to be nice like Taylor Swift?Haha i have the same hair long and curly..but not pretty curly! im completely obsessed with taylor and her hair so i did so playing with it and what you really NEED to get is the conair hot sticks!! they are these little flexible curlers and they are not very expensive and i would look like a frizz ball without them!! you can like get them at walmart. anyways what i do when iwear my hair curly is like i get up and get in the shower and wash it and condition it and this may sound weird but dont use a whole lot of conditioner just enough to get it done cause it will help your hair hold the curl the just get out and towel dry your hair till it is just damp and then put a curling mouse in it and frizz serum then finish blow drying it straight! and you know have the curlers on like when your gettin in the shower and then just make sure the little light is on meaning that they are hot enough and then seperate your hair into pretty small peices (if you have really thick hair then you might need to buy two sets cause they only have 14 in them and you use small sections) and then start from the botom of your hair and role it through your hair and pin it together youll see the instructions on how to pin them together and make sure you wrap it all the way to the top of your head and leave them for like 15 or 20 minutes while your finishin gettin ready and then use like a light hairspray about 5 minutes before you take them out then your done. i know this thing was really long but its not that hard lol!!!! hope i helped good luck!!!!!!!!
How Was the First Sale of Vivo X60 Series?
Huami Technology Held a Press Conference on August 27, and Amazfit Smart Sports Watch 3 Officially A
Connect to Nonencrypted Wireless Network Using Ubuntu Commands
Is Time Travel Possible? Can We Travel Back in Time?
Which Is a Better Design to Put on a Beer Pong Table?
What Else to Do on PS3?
How to Protect Data on IOT Devices
The Chromaticity of Solar Street Lamps Is Not Bright Enough?
JDI Officially Received Apple's $200 Million Investment to Pay for the Screen
related searches
What Are Some Ways to Keep My Hair Really Healthy?
How Was the First Sale of Vivo X60 Series?
Huami Technology Held a Press Conference on August 27, and Amazfit Smart Sports Watch 3 Officially A
Connect to Nonencrypted Wireless Network Using Ubuntu Commands
Is Time Travel Possible? Can We Travel Back in Time?
Which Is a Better Design to Put on a Beer Pong Table?
What Else to Do on PS3?
How to Protect Data on IOT Devices
The Chromaticity of Solar Street Lamps Is Not Bright Enough?

Copyright © 2020 Coffee bag - Guangzhou tianci packaging industry Co,. Ltd. | Sitemap